OWC Mercury Elite Pro Dual mini Guía de usuario descargar pdf (Pagina 10)

OWC Mercury Elite Pro Dual mini Chapter 2 - System Setup

2.1 Hard Drive Assembly & Installation (concluded)

➆ Using the included

screws from the plastic bag,

attach the drive mechanisms

to the enclosure through the

rubber grommets using your

Phillips P0 screwdriver.

It is recommended that you

start using 2 screws in each

drive, and not fully tighten

them until all 8 screws are

started into the drive mecha-

nisms.

Once you have installed the

drive mechanisms, simply slide

the inner chassis back through the

outer shell. The outer shell can be

installed in either direction, but

there is a notch on one side that al-

lows the back plate to t properly.

If your case gets turned around

and the back plate does not t cor-

rectly, try reinstalling it from the other side.

Then, place the rear port

cover onto the back of the

enclosure, and attach it using

the 2 Phillips screws and your

Phillips P0 screwdriver you

removed to begin the process.

➇

➈

RAID Conguration Note:

Before proceeding further, look at the next page of this manual, Section 2.2

RAID Conguration and conrm that the enclosure is properly congured

for the RAID type that you wish to use.

Failure to do this step before assembling the enclosure will result in you

having to dissasemble the unit to congure the RAID.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Sin comentarios

OWC Mercury Elite Pro Dual mini Guía de usuario Pagina 10