OWC Mercury On-The-Go Especificaciones Pagina 8
- Pagina / 24
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
OWC Mercury On-The-Go Pro Chapter 2 - System Setup
2 SYSTEM SETUP
2.1 Hard Drive Assembly & Installation (continued)
Slide the bridge card with the hard drive into the aluminum heatsink -
there is a notch that the bridge card will slide into.
Secure the hard drive using 4 screws from the included plastic bag,
through the heatsink, into the hard drive. Don’t overtighten, start all 4
screws before fully tightening.
Gently slide the completed heatsink, drive, and bridge assembly into
the acrylic enclosure. Take 4 Phillips screws from the included plastic
bag and once again, don’t fully tighten the screws, just start them,
as you will need to rock the assembly back and forth a bit to get all 4
screws started, then you can tighten them. Note that there is a rubber
mounting strip on the bottom of the heatsink, that makes it a bit di-
cult to get the screws all the way in. You may nd holding the enclosure
in your hand, screws down, works best.
- Assembly Manual 1
- 1 INTRODUCTION 3
- 1.1 System Requirements 3
- 1.2 Package Contents 3
- 1.3 About This Manual 3
- 1.5 Detailed View 4
- 2 SYSTEM SETUP 5
- (continued) 7
- 3 FORMATTING 10
- Windows 2000 and later 14
- 4.1 Troubleshooting 19
- 4 TROUBLESHOOTING & TIPS 19
- 4.2 Tips 20
- 5.2 About Data Protection 22
- 5 APPENDIX 22
- 6 CUSTOMER SERVICE 23
- R10 8/25/11 JD 24
Relacionado con productos y manuales para Hdd / ssd recintos OWC Mercury On-The-Go
Hdd / ssd recintos OWC EXPRESS Manual
(2 paginas)
(2 paginas)
Hdd / ssd recintos OWC EXPRESS Manual
(2 paginas)
(2 paginas)
Gai-tronics 12598-002 Redundant 5 V DC Module manuály
Uživatelské manuály a uživatelské příručky pro Komunikace Gai-tronics 12598-002 Redundant 5 V DC Module.
Poskytujeme 1 manuály pdf Gai-tronics 12598-002 Redundant 5 V DC Module ke stažení zdarma podle typů dokumentů: Uživatelský manuál
Comentarios a estos manuales